Humbucker Pickup Hot PAF Style Fits Gibson Epiphone Orville Tokai Greco Burny by Q pickups

This listing is for 1 pickup, shown on photos. It will work on bridge or neck position with Gibson and other humbucker and single coil pickups. Zebra butyrate bobbins. 4 – wire ground – for series/parallel/coil tap wiring options. – stamped nickel silver baseplate with 49.2 mm – 1 15/16″ pole spacing for both pickups, long legs, threaded pole screw holes enable contact between the pole screws and baseplates like in the original PAF pickups – vintage reproduction cream butyrate bobbins with offset square inside hole for slug side bobbin, black lead wires, mismatched DC resistance – wound with Elektrisola AWG 43 wire – rough cast Alnico 4 magnet bars – nickel plated steel screws and slugs – maple spacer – machined humbucker keeper bar – single conductor shielded wire with tinned braided copper shield – brass phillips bobbin mounting screws – coils and pickups are wraped with 50`s style black paper “flat-back” tape and then with black cloth pickup tape. You can see the DC resistance on the photos, measurements will vary depending on temperature.