Compatible with potentiometer knobs that have FINE KNURLING found on guitars made in the USA and Mexico. Assembled and soldered in our workshop using top components, ready to drop into your guitar! We professionally hand-soldered these harnesses using the best brand-name components for long life and great sound: 5-way switch USA Oak Grigsby split shaft CTS 250kOhm Audio Taper Potentiometers with fine knurling cloth covered push back Gavitt wire 0,033uF Paper In Oil Capacitor 200V 10% K40Y-9 assembled and soldered on a thin aluminum plate that will fit most Strat style guitars, both USA and import Switchcraft jack This is a vintage-style pre-1980 wiring harness, with tone controls assigned as follows: Tone 1: Adjusts the neck pickup. Tone 2: Adjusts the middle pickup. Bridge pickup: No tone control, just like 50s, 60s and 70s Stratocasters. If you’d like a tone control added to the bridge pickup, just send us a message, and we’ll make the adjustment for you! Switch: Bridge Bridge/Middle Middle Middle/Neck Neck 5-way Oak Grigsby Switch Specs Body cavity depth required 1-3/8″ (34.93mm) Mounting screw spacing 1-5/8″ (41.28mm) Lever stem .052″ x .188″ (1.32mm x 4.78mm) Pickguard slot required 1/16″ x 1-1/16″ (1.59mm x 26.99mm) CTS Control Pot Specs Resistance 250K-ohm Shaft diameter 0.235″ (5.95mm) split shaft, fine knurling Thread 3/8″ x 32 Threaded portion height 3/8″ (9.52mm) Mounting hole diameter 3/8″ (9.52mm) N.O.S. Paper in Oil Capacitor Specs Value .033uF, 10%, 200V Switchcraft Output Jack Specs Accepts standard 1/4″ plug Mono Mounting hole diameter 3/8″ (9.52mm) Thread 3/8″ x 32 Threaded portion height 1/4″ (6.35mm) Stratocaster®, Strat®, and Squier® are registered trademarks of Fender Musical Instruments Corporation.
